After Landing Steps

Lower Pedestal

The following actions should be performed on the lower pedestal

Left Side Lower Pedestal

Set your radio frequency to the one assigned by ATC
- ATC is set in accordance with airport requirements
Disarm the spoilers by pushing down on the lever
Set your ENG mode selector to NORM

Right Side Lower Pedestal

Retract your flaps to ZERO
Set your TCAS to STANDBY
Set your radar OFF
Set your predictive windshear system OFF

Overhead Panel + Center Instrument Panel

The following actions should be performed on the overhead panel and the center instrument panel. Make note of the ECAMs when checking for brake temperature.

Overhead Panel

Start your APU by clicking the APU master button then the APU start button
Turn OFF your anti-ice if it is not required

Set your exterior lights:

Set your noise wheel light to TAXI
Set Runway turn-offs ON
Set your strobe lights to AUTO/OFF (If you are crossing runway keep them ON until you vacate the runway)
For landing lights, you can choose to retract them or turn them off

Your lights should look like one of the following:

Lights Setup 1

landing light positions